Available after version: 1.11.392.3
This feature allows to calibrat/Zero-offset the ANT+ Power meters to allow its operation at highest degree of accuracy.
This should be possible for meters supporting Auto Zero Configuration to be able to configure auto-zero on and off.
Step 1: Tap on the sensors app and select your Power meter connected over ANT+. Figure 1
Make sure the sensor is enabled and is transmitting live data.
See: How-to: Add ANT+ / BLE sensors
Step 2: Scroll to the bottom of the screen and tap on 'CALIBRATE'. Figure 2
Step 3: The message would appear on screen when the calibration begins, 'Calibrating sensor'.
Step 4: When the calibration is completed, a confimation prompt would appear 'Calibration
succesful'. A notification would be available too on the top bar once this is completed.
Figure 4 & Figure 5.
Note: If you get an error message "Error code: TIMEOUT", close the sensor app and follow the steps again while the Power meter is still connected and live data is streamed. Figure 6