Wahoo Kickr V5 trainer control
Answered
I have no trainer control. Yesterday everything worked fine. I didn't change anything.
At the sensor page (trainer ID), ANT+ and BLE the icons are all showing green. When I pedal power, cad an speed are showing.
I also deleted the ANT+ and tried with BLE and vice versa.
I tested my trainer with the Wahoo phone app. All good. I can change the wattage in ERG mode.
When I start pedalling all data power, cad, hr are showing in the fields of the second data page. There are no + and - icons on the workout page.
No control of the trainer.
-
@Sergo: Sorry to hear about the trouble that you have encountered. We would like to investigate the issue further.
Could you please follow the below steps and see if that resolves the issue or not?
- Delete all the sensor's from Karoo 2 from the "Sensor" App.
- Start searching for sensors
- Pair the Trainer ID over ANT+ (Do not pair it over Bluetooth)
- Please make sure that you are not pairing any sensors over Bluetooth while testing this.
- Keep the Trainer ID on top of the sensor's list.
- Once it is connected over ANT+, load a workout on your Karoo 2 and check if the Karoo 2 is controlling the resistance or not.
- If not, please let us know.
-
Hari, it works ! I followed all the steps. And put the sensor on top of the list.
When I load a workout , it controls the resistance.
I also did a test, without loading a workout. The so-called 'free ride' where you set resistance during the ride (aka Garmin). This was not possible. Not supported I guess. -
@Serge: Glad to hear that it worked. If you connect the Trainer ID, it will be in default ERG mode and it controls the resistance while doing the structured workouts as we support only Target based workouts as of now. If you do not connect the Trainer ID and pair other sensors, you can do the free ride and track the data on the normal data screens.
Please sign in to leave a comment.
Comments
5 comments