SRAM TyreWiz, false positives continuosly

I have 2 sets of TyreWiz. I love the new interface and the data offered, but it has a small problem of constant false positive warnings, every time a sensor has a small disconnection or fluctuation (microcut), the warning is triggered.

The warning in case of detecting a pressure below a set value, it should notify immediately, but the microcuts in the sensors are very common, and in each exit I always have 5 - 10 warnings with both bikes, which means that I no longer pay attention (in addition which is annoying), and the day I have a flat tire, I will not attend to the warning

Is it possible to add a delay of a few seconds (2-3" perhaps) before notice? That way we would avoid the problem. Thanks

Hari Krishnan

February 04, 2023 14:10

@Toni: Thank you for bringing this issue to our attention. We would like to investigate the issue further. For this, I have created a support ticket and requested some information from you. I request you follow-up on the ticket with the requested details.

Antonio Tijeras Alonso

April 14, 2023 04:55

just to remember that this bug is still active, and it usually jumps me at least 1 time (up to 6-7 times) in each ride. I have found that it usually jumps when I stop for a few seconds and shortly after resuming. Is very annoying!

SRAM TyreWiz, false positives continuosly

Comments

Didn't find what you were looking for?