No manual elevation in settings app stored

Answered

Follow

brausche

• February 28, 2021 09:09

Dear All,

it is possible to use the automatic barometric settings for elevation or to set the elevation manually. But the manual input is never stored. Karoo2 always uses an automatic calculated elevation, although manual is selected. Anyone else experienced this behavior?

 

0

• 

  Ali

  • March 01, 2021 07:26
  • Edited

  Hi Brausche - this is possible, and here are the steps
  https://support.hammerhead.io/hc/en-us/articles/360051738614--Manually-Calibrating-the-Elevation-Reading-

  I am not sure if you are facing any issues so please let me know

  0

  Comment actions Permalink
• 

  Ludwig Mauren

  • April 05, 2021 11:40

   

  All entries on the page "Elevation Calibration" lead to an error-message : Elevation calibration failed

  0

  Comment actions Permalink
• 

  David Fox

  • April 05, 2021 13:10

  I had this issue when I was first learning the K2. Check to make sure that GPS is turned on in Sensors.

  0

  Comment actions Permalink
• 

  Ludwig Mauren

  • April 05, 2021 15:29

  I found out that this behavior does not depend in switching the GPS sensor on or off.
  It is related to the presence of the current GPS signal.
  The error messages should be made a little bit more informative.

  1

  Comment actions Permalink
• 

  Steve

  • April 05, 2021 18:38
  • Edited

  Yes, I agree with this. Simply displaying an error message with "Elevation calibration failed" is not super helpful; it would be good to understand why. Invariably, this is because there is no GPS signal.

   

  0

  Comment actions Permalink

Please sign in to leave a comment.