Varia radar doesn't connect while already in ride

Answered

Follow

Martin Bednarik

• April 10, 2021 18:44

Repro steps:

1. Radar is turned off
2. Start recording a ride on K2
3. After good 5 minutes I turn on the radar
4. Radar doesn't connect unless I toggle Sensors from notification bar or go into Sensors settings and into Radar and toggle ENABLED option there

The same behaviour when I put radar into standby mode which causes disconnect as well. Then I stop riding which pauses the recording. I took off in few minutes, turn on the radar and again, it doesn't connect unless I do the toggle workaround

 

0

• 

  Dakota

  • April 15, 2021 12:05

  Hey Martin,

  Thank you for reaching out! Can you confirm the connected ANT+ Smart Light is enabled prior to starting the ride? If the ANT+ Smart Light is toggled to disabled then this is normal to have to enable the sensor in order to connect. Please be sure to check out our latest article around ANT+ Smart Light Integration & be sure to let me know if you still have questions.

  I'll link this article below.

  • https://support.hammerhead.io/hc/en-us/articles/1260804314929-ANT-Smart-Light-Integration

  Thanks again for reaching out & being part of the community!

  0

  Comment actions Permalink
• 

  Martin Bednarik

  • April 16, 2021 15:04

  Hi Dakota,

  I verified my sensors settings and both Radar and Light are enabled.

  I believe the problem is in Karoo software that essentially stop searching for a sensor while already being in-ride for some time. Can you try to duplicate this as I posted in repro steps above?

  0

  Comment actions Permalink

Please sign in to leave a comment.