Remove the two screws in the bottom shell with the T8 Screwdriver provided.
Remove the bottom shell by holding the top of the Karoo, grabbing the lower buttons, and pulling down to slide off. The lower shell needs to be slid down ~5 mm to disengage from the upper shell.
Remove the top shell and set it aside.
Clean any dirt or debris from the Karoo with a clean lint-free towel.
Install the new top shell and make sure it is fully seated. To make the installation easier, pull the USB cover port out so it is hanging from the bottom shell.
Install the new bottom shell by inserting the left side of the shell, then working on the bottom, then the right side. Keep the button retention tools in place until the shell is fully assembled. Re-install the USB port cover and make sure everything is fully seated.
Install and tighten the new screws using the provided T8 Screwdriver. 0.2 N⋅m (1.7 in-lb). Install and tighten the new screws using the provided T8 Screwdriver. 0.2 N⋅m (1.7 in-lb) Remove the power buton sticker to install the second screw.
Remove the side button retention tools. These tools are reusable for reinstallation of bottom shells.
Comments
0 comments
Article is closed for comments.